filter input to reduce 'noise'

 Added C3 on input to modify the response.

The amp response

 

Click EDIT

Click SPICE Analysis

Fill in the 4 blanks to define the sweep.

Rod tube radio

 interested in rod tubes? This radio provides examples of their uses.

Emitter bypass cap

 When you begin to analyze a circuit the first step is to open the caps and short the coils. Then analyze the DC paths. Establish the bias to determine the Q points.

The AC function can be seen by adding the caps and coils back in the circuit. If you build a sim with no caps and then add the AC signal you will have degenerative feedback developed across the DC bias components. Build an alternate AC signal path with the caps allow the AC impedance to be different from the DC resistance.

So remove the bypass and look at our circuit.

The circuit is functional. It produces a good signal. (faithful, linear )

Not put the bypass back in.

We get a higher gain but the signal is less faithful.

You can remove the source bypass and get the same results.

We see builders who make (regenerative) receivers with audio amps. (or so they say)

If you have a strong station in your area you could connect an antenna to the input and receive the station. Is it a regen receiver?

Consider this before answering.

As the circuit was first presented you would have some 'drain bend' which could allow it to be used as a receiver. Try adjusting the source bypass and see what happens.

Some drain bend there.

So you can change the component values and see the effects.

The simulator will present garbage in - garbage out effects but more on that latter.

I will try and present some more sim function as we go through more circuits.

For now one point to consider is the lib is built by pro's and work quite well so after you built a circuit use the select component option to ensure you are using a 'full' representation.

later.....

A series with mods to the grounding and size of drain cap

Setting the probe to reference the drain. With the sim running click on schematic to open the menu.

and set the reference.

 The point I want to make is the drain and source caps are 'juggling' the current. One charges as the other discharges. If they are small they limit the current. Set them to 25ufd and see what difference it makes.

A quick look at RC time constant

The natural log function defines the RC charge and discharge.

TC = R * C 

Things to consider:

As power is applied the current is limited by the resistor.

As the cap charges current drops.

Once the cap is charged current ceases to flow. (actually the cap never receives full charge but we call it charged after 5TC.)

My internet flaking in and out. Before I save the file somethings to consider.

TC = RC

Period = 1/T

Frequency = 1/P

The current flows as a cap charges.

If it is to small it will follow the wave form as it charges and discharges.

If it is to large it will charge and hold the peak.

In our amp we want the cap to be able to pass the AC component. Which means we do not want it to charge and hold.

So if we know F=1/P and TC=RC can we imply F=RC as the factor to determine the Cap size?

Would we set the low frequency = RC as the value to use?

More later....

Getting failed to update error.

Try again.

A little more on layout.

 

I'm putting this here so you can consider the fields. Maybe we will come back to it ?