Friday, August 17, 2018

loop update

A quick update on this project. When I installed the plastic tubing for the wire hangers I let it protrude out front and back.
When I blow it up it became a little grainy but you can see the tube. I wrapped one side with a single turn and the other with the ribbon cable. When I get back to the loop I will put a switch so I can select the taps on it. One side will be antenna and ground the other side will be the radio input.
The switch taps will be the terminals for the coil. I may come back and put ribbon on the side with the single loop after I see how it works.

I checked the single turn and it was about 12 uh. If memory serves I didn't write it down.

No comments:

Post a Comment