I put down copper foil for ground and screwed terminal in for the tie points. I numbered them to try and not get confused. Then it was tie the components between the tie point while referring to the drawing.
Tuesday, September 26, 2017
The second generation oscillator
Putting the second generation oscillator on board
I printed the circuit out.
Number all the points. Zero is ground and then just number the tie points.
I put down copper foil for ground and screwed terminal in for the tie points. I numbered them to try and not get confused. Then it was tie the components between the tie point while referring to the drawing.
After wiring it up I put 6.2 volts on it and got 383 mv Pk-Pk with a one turn feedback.
I put down copper foil for ground and screwed terminal in for the tie points. I numbered them to try and not get confused. Then it was tie the components between the tie point while referring to the drawing.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment